HP 1810-8G How to reset J9802A to factory default

Here is a steps to reset HP 1810-8G / J9802A to factory default

1. On the front panel of the switch, there is a Reset and a Clear button.

2. Press and hold both buttons for a few seconds, then release the Reset button while continuing to hold the Clear button.

3. Check the LED Mode lights on the left side of the switch (Act, FDx, and Spd).

4. Once the LEDs flash twice, release the Clear button and allow the switch to finish booting.

This should reset the switch back to factory defaults. The switch will now have a factory default IP address of 192.168.2.10.